P-Wood is water based, as such it should never be applied if the surface temperature is low enough to freeze the material, (i.g., An air temperature below 40 degree F).

CAUTION - PLEASE NOTE:

1. Do not apply P-Wood to glass, glazed surfaces, or aluminum, as etching will occur. In case of accidental contact, rinse thoroughly and immediately with water.
2. P-Wood is not meant to fill or seal visible cracks in wood.
3. For surfaces not specified in our literature or if you are uncertain as to previous chemical treatments, (on the surface to which you are considering applying P-Wood), we recommend that P-Wood be applied to a small test area first.
4. If P-Wood becomes frozen, thaw out completely and shake well to fully remix the material prior to using. Freezing will not harm the product.

Disclaimer

We believe this information to be true to the best of our knowledge. Our products are of the highest quality and uniform within manufacturing tolerances.

Since no control is exercised over product use, no warranty, expressed or implied, is made as to the suitability of products for a particular use or as to the suitability of products for a particular use or as to the effect of such use, and no liability is assumed, directly or indirectly.

Buyers and users are encouraged to conduct their own tests prior to application.