Log-Gevity Bio-Strip, designed for exterior use, is a multi-purpose stripper, cleaner, refinisher and more. It is formulated to remove a wide variety of coatings from many types of substrates. This product is unique because it is biodegradable, non-flammable, nonacidic, contains no methylene chloride and does not require neutralizing. Log-Gevity Bio-Strip Gel dwells longer providing deeper penetration on multiple layers of paint.

Precautions: Read the entire material safety data sheet and product label for a more thorough evaluation of hazards. Fully protect all adjacent surfaces, as well as floor and general work area, from coming into direct contact with Log-Gevity Bio-Strip.

Caution: On glass surfaces, all Log- Gevity Bio-Strip overspray and/or residue from the stripping process must be immediately removed to avoid adherence to the glass surface.

TECHNICAL DATA

Color/Form: Reddish-brown gel.

Coverage: Bio StripTM Gel: 50-100 sq. ft. per gallon, depending on layers of paint to strip.

Packaging: One and five gallon containers.

PROPER SURFACE PREPARATION

Prepare a surface free from dirt and oil. It is not necessary to remove loose, peeling or flaking paint. This creates pockets down to the surface which is generally more absorbing than the painted surface.

A test area should be performed prior to beginning overall project to determine optimum dwell time for the product to completely penetrate all layers of the finish.

User shall determine the suitability of the product for its intended use and assumes all risk and liability whatsoever in connection therewith. Follow all local, state, or federal disposal regulations when using the product.

GENERAL DIRECTIONS

1. Using a brush, roller, low pressure (HVLP) sprayer or airless paint sprayer, apply a thick coat of Log- Gevity Bio-Strip to surface.

   Caution: Log-Gevity Bio-Strip is slippery when applied to surface. Use extreme caution when working on horizontal surfaces.

2. Allow Log-Gevity Bio-Strip to remain on the surface until finish has dissolved. To prevent premature rinsing, wait for the entire surface to become uniformly darkened. This darkened appearance indicates that the Log-Gevity Bio-Strip has dissolved the underlying finish and is ready to be rinsed.

3. Reapply Log-Gevity Bio-Strip if necessary.

REMOVAL

1. If possible, scrape all dissolved residue and discard in an appropriate container.

   Note: If logs/wood become discolored, leave a solution of Log-Gevity New Log Prep on the discolored area and allow to dry. Acrystallized residue will appear when the Log-Gevity New Log Prep dries. Lightly remove crystals from surface without destroying the brightening action of the Log-Gevity New Log Prep with a very light water rinse.

2. Certain types of log/wood surfaces may have raised grain after stripping is completed. Sanding may be necessary. Sand when surface is dry or brush with stiff bristle brush while surface is wet to smooth out this condition.