PRODUCT DESCRIPTION
Log-Gevity Citrus Log Stripper is a
unique formula for the removal of failed
log finishes. Log-Gevity Citrus Log
Stripper contains no methylene chloride
and no neutralizing is needed. The pH
balance is non-damaging to logs, future
finishes, wood, masonry, plastered walls
or metals. It is designed to remove multiple
layers of finish, varnish, stains, latex
paint and oil paint. It is recommended for
log exteriors and interiors. It can also be
used on fine furniture and cabinets. Log-
Gevity Citrus Log Stripper remains
moist and active longer, thus penetrating
more layers in one application.
Note: Log-Gevity Citrus Log Stripper
may damage or soften asphalt, plastic,
rubber, tile, linoleum, anodized aluminum
and adjacent painted surfaces.
Log-Gevity Citrus Log Strippers are
ideal for intricate carvings, moldings, pillars,
fine furniture and antiques.
When applied uniformly, Log-Gevity
Citrus Log Strippers penetrate multiple
layers of paint mil thickness and
reduce the water rinse normally
needed to dissolve stripper residue.
The special paste formula stays wet and
active longer than conventional strippers.
In some cases, the paste formula may be
removed and reused on multiple surfaces
of your current stripping project.
Log-Gevity Citrus Log Stripper Gel
provides a less viscous consistency than
the paste formula.
Log-Gevity Citrus Log Stripper is ideal
for refinishing work and will remove thin
layers of varnish, stain and graffiti.
Precautions: Read the entire material
safety data sheet and product label for a
thorough evaluation of hazards.
Fully protect all adjacent surfaces
including vegetation from coming in
direct contact with Log-Gevity Citrus
Log Strippers. When stripping interiors,
lay plastic sheeting on the floor
and cover with stacks of newspaper or
cardboard to absorb scraped residue.
USE ONLY WITH ADEQUATE VENTILATION!
Close container after each use. Avoid
inhalation and use only with adequate
ventilation. If using indoors, open all
windows and doors and make sure
there is fresh air movement. If adequate
ventilation cannot be maintained, wear
respiratory protection or leave the area.
CAUTION! This product is combustible.
Keep away from heat, sparks, flame
and all other sources of ignition.
Eye Protection Required when using
Log-Gevity Citrus Log Stripper. Wear
chemical splash proof goggles.
TECHNICAL DATA
Color/Form:
Log-Gevity Citrus Log Stripper Pasteputty-
colored thick paste.
Log-Gevity Citrus Log Stripper Gelputty-
colored gel.
Coverage:
Note: Product may be reusable on
some finishes, increasing the amount of
coverage per gallon. The amount of
coverage may also vary depending on
the surface and the layers of finished to
be stripped.
Log-Gevity Citrus Log Stripper Paste
25 to 75 square feet per gallon.
Log-Gevity Citrus Log Stripper Gel-
75 to 125 square feet per gallon.
Packaging: One and five gallon
containers.
PROPER SURFACE PREPARATION
Preparatory Work: Prepare a surface
free from dirt and oil.
Prior to beginning the overall project, a
test should be performed to determine
the optimum dwell time for the product,
the number of applications necessary to
completely remove all traces of finish
from the surface, and if any Log-Gevity
Citrus Log Stripper may be reused for
additional application(s).
The user shall determine the suitability of
the product for its intended use and
assumes all risk and liability whatsoever
in connection therewith.
GENERAL DIRECTIONS
- A. Apply Log-Gevity Citrus Log
Stripper Paste approximately 1/8
- 1/4 inch thick with a trowel or
brush.
B. Apply Log-Gevity Citrus Log
Stripper Gel with a natural bristle
brush, roller, low pressure (HVLP)
sprayer or airless sprayer.
- allow Log-Gevity Citrus Log
Strippers to remain on the surface until
all paint is dissolved. Log-Gevity
Citrus Log Strippers will penetrate an
average of one (1) layer of paint every fifteen
(15) to thirty (30) minutes.
Note: Product efficiency is slower in
cooler temperatures.
Note: Log-Gevity Citrus Log Stripper
Paste and Gel may sag if applied too
thick over latex finishes. If sagging
occurs, apply thinner coats of Log-
Gevity Citrus Log Stripper. Allow the
product to dwell for one (1) hour and
apply a second coat directly on top of the
first coat.
REMOVAL
- Scrape away the dissolved residue.
Forming a membrane may require
leaving Log-Gevity Citrus Log
Stripper on the surface beyond 24
hours depending on the temperature and
humidity. Rinse the surface with a clean
sponge or scrub brush and clean water to
remove excess Log-Gevity Citrus Log
Stripper residue.
Note: Beware of wind drift onto adjacent
surfaces while rinsing or applying Log-
Gevity Citrus Log Strippers.
Note: A soft wire brush may be used to
remove dried product missed during rinsing.
- Log-Gevity Citrus Log Strippers do
not require neutralization.
STORAGE: Log-Gevity Citrus Log
Strippers should always be stored in the
container in which it was purchased.
DISPOSAL: Contact local, state and/or
federal agencies to ensure compliance
with regulations governing the disposal of
this product along with coatings and
finishes that may be removed when
using this product.
WARNING: This product contains a
chemical known to the State of California
to cause cancer, birth defects or other
reproductive harm.
